As long as step 7, you can restore the surface of any cube 6
As long as step 7, you can restore the surface of any cube 6
Crack tips and to share with you below:
First, crack the Rubik's Cube, we have to first understand its structure, a total of 6 color 6 side cube, each side is divided into the central block (the most middle of the block 6), corners (4 corner block
and the side block (4 at the edge of the block 12). Of which only one side the central block, they are fixed structures, so central is the red block, then the red should be the other side to this focus. And red is always opposite the central block of the central orange block (international standard is so specified). The edge pieces have two face two colors, corner block, there were three face three colors.
Next we will have letters on behalf of each side,
Sometimes we then break Gonglue letter to explain to a layer or a rotating surface, and direction: for example: R (on behalf of the right side clockwise 90 degrees), R `(on behalf of right turn 90 degrees counterclockwise), R2 (on behalf of right 2 90 degrees clockwise)
Here's icon:
Finally, a note is: the name of each side is relative, such as F is a front, that is, when the hand cube for their side, if the imitation of rotation to the other side, then there is a new side in front.
Well
Here let us try the next step 7 to restore the cube it!
1. First side of the middle is the white block (with a rubiks
logo of the piece) against the above, and then make a white cross at the top, that is, all other colors of the blocks to the appropriate position (small complex, see picture, note the subject of the above formulas Oh, did so correctly)
2. Then the white corner block homing (Cheats said complex or easier to understand Rights Figure)
3. Then let the middle side block homing.
Under the white face turned to find the red and green side block, if the red and green on the top side of block rotation according to the top clockwise until the edge on the block and Figure 1 are the same, in accordance with the formulas rotating cube, so that edge blocks are classified bit. If the red and green side of a block in the middle layer, but the location of errors or color errors, the first to make red and green blocks in the right front side of the position, again the order of rotation in accordance with one of the following 1.
4. And then the top (should be yellow) side block to adjust upward, making yellow cross. If the rotation in accordance with formulas 1, the top not a yellow cross, repeatable formulas by turning, until the yellow cross appears.
5. Then adjusted to cross the yellow blocks around the corner, a little difficult to see formulas suggest it.
6. Usually this time yellow block, and the side of the color will be produced dislocation, according to formulas (I have not fully digested) to locate the four corners of the yellow block.
7. Finally, the edge of the blocks of color and then adjusted to correspond to the location. You're done! ! Under excited.
http://www.360doc.com/showWeb/0/0/24787106.aspx








pieces allowed maximum will be put off by heart satisfaction and enjoyment, is not it?
really, how many?